USB To UART Converter-EE2410N-CC10R1

This is a USB2.0 to TTL UART Converter module which is based on CP2102 Bridge by SiLabs. This module can be used with Laptop's which don't have a standard serial port. This module creates a virtual COM port using USB on your computer which can support various standard Baud Rates for serial communication. You just need to install the driver using a setup file which automatically installs correct driver files for Windows XP/Vista/ 7. After driver installation, plug the module into any USB port of your PC. Finally, a new COM port is made available to the PC. The feature which makes it more convenient is the TTL level data i/o. So you don't need to make an RS232 to TTL converter using chips like MAX232. The Rx and Tx pin can be connected directly to the MCU pins (assuming 5v i/o).

Specifications

·       Stable and reliable chipset CP2102.

·       USB specification 2.0 compliant with full-speed 12Mbps.

·       Standard USB type A male and TTL 6pin connector.

·       6pins for 3.3V, RST, 5V, GND, RX, and TX

·       All handshaking and modem interface signals.

·       Baud rates: 300 bps to 1.5 Mbps.

·       Byte receives buffer; 640 bytes transmit buffer.

·       Hardware or X-On/X-Off handshaking supported.

·       Event character support Line break transmission.

·       USB suspend states supported via SUSPEND pins.

·       Temperature Range: -40 to +85.

·       Size: 42mm X 15mm.

·       Weight: 4g

Pin Details

·       TX = Transmit Output - Connect to Receive Pin(RX) of Microcontroller. This pin is TX pin of CP2102 on board.

·       RX = Receive Input - Connect to Transmit Pin(TX) of Microcontroller. This pin is the RX pin of CP2102 on board.

·       GND = should be common to microcontroller ground.

·       5V = Optional output to power external circuit up to 500mA

·       DTR/RST = Optional output pin to reset external microcontrollers like Arduino.

·       3V3 = Optional output to power external circuit up to 50mA.